Iris Technology Operator's Manual
QuietPower 1800 (QP-1800) Doc 287.F701 / 100412
Page 8 of 56 Rev 12 APR 2010
WARNING
MAKE SURE INVERTER IS ELECTRICALLY DISCONNECTED FROM 24
VDC POWER SOURCE (NATO PLUG) PRIOR TO SERVICING. FAILURE
TO DISCONNECT INVERTER FROM 24 VDC POWER SOURCE (NATO
PLUG) FIRST MAY RESULT IN FIRE, SEVERE ELECTRIC SHOCK, OR
DEATH.
WARNING
DO NOT DISASSEMBLE THE QUIETPOWER INVERTER. ONLY
QUALIFIED ELECTRONICS MAINTENANCE TECHNICIANS ARE
PERMITTED TO REPLACE THE FUSE. ATTEMPTS TO SERVICE THE
INVERTER BY UNQUALIFIED PERSONNEL MAY RESULT IN A RISK OF
ELECTRIC SHOCK OR FIRE. REFER TO SECTION 7, WARRANTY AND
SERVICE, FOR INSTRUCTIONS ON SERVICING THE INVERTER.
CAUTION
Review the Important Safety Instructions found at the beginning of this
manual and read this entire section, paying particular attention to the
CAUTION and WARNING statements, before proceeding with the
installation.
CAUTION
It is recommended that you read the entire wiring instruction Section first
before attempting to wire the Inverter
CAUTION
Make sure cable is connected properly: positive (+), red wire to left post
and negative (-), black wire to right post. Connecting cable improperly
may result in internal damage to inverter.