Iris Technology Operator's Manual
QuietPower 1800 (QP-1800) Doc 287.F701 / 100412
Page 41 of 56 Rev 12 APR 2010
5.4 Storage
When storing the QuietPower Inverter, follow the environmental conditions specified below.
No rain, snow, spray, bilge, or dust
No salt spray
Low humidity
Cool and dry
Out of direct sunlight
5.5 Preparation for Shipment
The QuietPower Inverter contains sophisticated internal electronic circuits that can be damaged
if the inverter is bounced around or dropped. Approved shipping methods are as follows:
Save the original packaging material. The inverter shall be shipped back to Iris
Technology for repair and the preferred method of shipping is to use the same
packaging material that was used when first shipped from the factory. Make sure the
inverter is secure in the packaging and will not be damaged by rain, snow, spray,
bilge, or dust.
If a transportation case is available, the case can be used for shipping provided it is
packaged properly with adequate packaging material surrounding the inverter. Make
sure the inverter is secure in the packaging and will not be damaged by rain, snow,
spray, bilge, or dust.
Use Military or commercial transport companies to prepare the inverter for shipping.
Make sure the inverter is secure in the packaging and will not be damaged by rain,
snow, spray, bilge, or dust.
The remainder of this page is intentionally left blank
To Next Page
Loading...
General