Iris Technology Operator's Manual
QuietPower 1800 (QP-1800) Doc 287.F701 / 100412
Page 43 of 56 Rev 12 APR 2010
6.2.2 Cleaning
The QuietPower Inverter contains sophisticated internal electronic circuits that can be damaged
if debris or foreign matter enters the inverter casing. Clean the QuietPower Inverter and NATO
Cable in accordance with Table 10.
CAUTION
Do not use harsh or abrasive cleaners on the QuietPower inverter or
NATO cable. Do not use petroleum-based products of any kind. Damage
can result if these precautions are not followed. Use only a non-abrasive
cloth dampened with soap and water to clean inverter and NATO cable.
Do not attempt to flush the unit with liquids of any kind.
Table 10: Cleaning (Internal)
Be sure the inverter is switched OFF and
disconnected from any power source for at least 5
minutes.
Perform Cleaning (External ) procedure.
Remove 14 screws attaching the outer housing.
Using a compressed air duster, blow out any debris
(dirt, sand, etc).
Remove any visible debris, dust, and sand that may be
contaminating the electronic circuitry.
To Next Page
Loading...
General