I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 12
FOR SIMULATION USE ONLY – NOT A TRAINING AID
HEAD-UP-DISPLAY (HUD)
The TEXAN II HUD can exhibit a small white artifact at night on some systems. To
address this, perform one of the following corrective actions:
1. Turn NANOVG rendering OFF.
(Options->General Options->Experimental->NANO VG->OFF)
2. Reduce the brightness of the HUD.
3. Switch the HUD from TEXAN II to F-35 Symbology via the Right MFD
CONFIG Page.
FLIGHT MANAGEMENT SYSTEM (FMS)
The IRIS TEXAN II doesn’t feature FMS functionality outside of the scope required to
display flightplan data.
TRIM AID DEVICE (TAD)
We recommend that you turn on AUTORUDDER in the assistance settings to
simulate the use of the Trim Aid Device (TAD).
(Options->Assistance Options->Piloting->AUTO-RUDDER).
NOSE WHEEL STEERING (NWS)
To operate the Nose Wheel Steering, please ensure you have a control binding tied
to the ‘TOGGLE G LIMITER’ function. This will toggle the Nose Wheel Steering on and
off.
SMOKE GENERATORS
To operate the smoke effects on any of the aircraft for aerobatics, please ensure
you have a control binding tied to the ‘TOGGLE WING LIGHTS’ function.
Operation of the smoke system through the above function is dependent on the
following factors:
1. The SMOKE option in the CONFIG page on the MFD should show ARMED
and not OFF.
2. When you then use the control binding for the LOGO LIGHTS, ‘SMOKE’ is
indicated on the EICAS to indicate that smoke is being dispensed.
To Next Page
Loading...