EasyManua.ls Logo

IRIS TEXAN II - Take-off Operations

IRIS TEXAN II
219 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 182
FOR SIMULATION USE ONLY – NOT A TRAINING AID
BEFORE TAKE-OFF
1. Minimum power at 60 KIAS – Compute
2. Speed brake – Retracted
3. Flaps – TO
4. Trim – Set for take-off
(Set all three trim positions to indicate within the green ranges on the trim
indicator.)
5. MFD/UFCP/REPEAT/NORM select switch – As required
6. Fuel quantity and balance – Check
7. Engine instruments – Check
8. DVR control – As required
9. Amps – Verify +50 amps or less
10. DEFOG switch – OFF
11. Seat safety pin – Confirm removed and stowed (BOTH)
12. ISS mode selector – As required (Verify ISS mode selector lever is locked in
desired detent)
LINEUP CHECK
1. Landing/taxi light – ON
2. Transponder – Mode to ALT
3. Nose wheel steering – Off
4. PROBES ANTI-ICE switch – ON
CAUTION
Prolonged use of pitot and AOA heat while on the ground will damage the
pitot and AOA heating elements.
5. EICAS display – Check (BOTH)

Table of Contents