I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 173
FOR SIMULATION USE ONLY – NOT A TRAINING AID
7. Flight controls – Check (BOTH)
(Visually check for free and correct movement and verify full control range is
available at selected seat height.)
8. Fire detection system – TEST (FIRE 1 and FIRE 2) (BOTH)
9. LAMP test switch – Check (BOTH)
(Check for MASTER WARN and MASTER CAUTION [front cockpit only], red
gear handle, red and green gear, FDR lights, gear door lights, fire lights, and
COM 1 and COM 2 transmit illuminate and LAMP TEST on EICAS.)
10. Flaps – UP
11. Exterior lights – OFF
12. TRIM DISCONNECT switch – NORM (BOTH)
13. Interior lights – As required
14. TRIM AID switch – OFF
15. Trim operation – Check (BOTH):
a. Aileron, elevator, and rudder trim – Check
b. Elevator and aileron trim – Set for T/O
(Set elevator and aileron trim to respective green ranges.)
c. Rudder trim – Set outside green range.
(Set rudder trim out of green range to check/verify correct TAD operation
during the Before Taxi checklist.)
16. EMER LDG GR handle – Check stowed
17. MASTER ARM switch – Safe
18. Clock – Set
19. UFCP lower panel switches – Set:
a. HUD TEXT/FPM UNCAGE/CAGE – CAGE
b. LGT NIGHT/DAY/AUTO HUD – AUTO HUD
c. MFD/UFCP/REPEAT/NORM – NORM
d. LGT-BRT – As required.
To Next Page
Loading...