I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 179
FOR SIMULATION USE ONLY – NOT A TRAINING AID
12. Flaps – Check (ground crew observer if available) (BOTH):
a. Set flaps LDG – Verify flaps move to LDG, indicator reads LDG, and speed
brake retracts (message extinguishes)
b. Set flaps TO – Verify flaps move to TO and indicator reads TO
c. Attempt to extend speed brake – Verify speed brake does not extend.
13. TRIM AID switch – ON:
a. Verify TAD OFF message extinguished.
b. Verify yaw (rudder) trim set-in green range (T/O)
14. PARKING BRAKE – Release
15. Nose wheel steering – ON
(Limit taxi speeds to the equivalent of a fast walk with nose wheel steering
engaged.)
16. Brakes – Check (BOTH)
17. FMS – Check
18. TCAS – ON/TEST
19. UFCP and MFD – Set flight information as required:
a. INS/GPS – Aligned and location crosschecked.
b. UHF – As required.
c. VHF – As required.
d. VOR – As required.
e. Transponder – Standby
f. FMS – As required.
g. Altitude, G, speed, fuel flags – Set (as required)
20. Flight Instruments – Check pitch, roll, and heading indications, and no flags
21. Altimeters – Set and check (BOTH)
22. Seat safety pin – Remove and stow (as required)
(show to ground crew observer if available) (BOTH)
To Next Page
Loading...