I A P 2 0 2 3 . 0 0 1 - A F M / I R I S T E X A N I I P A G E | 193
FOR SIMULATION USE ONLY – NOT A TRAINING AID
BEFORE LEAVING AIRCRAFT
1. PARKING BRAKE – As required
(If wheel chocks have been installed or if the aircraft is tied down, release
the parking brake.)
2. CFS handle safety pins – Install (BOTH)
3. DTS/DVR cartridge – Remove (as required)
4. ISS mode selector – SOLO
(Verify ISS mode selector lever is locked in SOLO)
5. Oxygen hose and communication cord – Stow with loop forward
6. HUD combiner cover – Install
7. Wheel chocks – Install (as required)
8. Exterior walk-around inspection – Visually check:
a. Ground for evidence of fuel or hydraulic leaks
b. Flap condition
c. Speed brake condition
d. Gear, gear doors, and wheel well condition
e. Tires for indication of wear, cuts, or blisters
f. Access doors, panels, fairings, and ventral fin for damage or missing
fasteners
g. Rudder – Locked (as required)
To Next Page
Loading...