34
-
CONTINUED
PROGRAMMING A DELAY
BETWEEN
STATIONS
Use this feature any time you need a delay between stations. The delay
can be from 1 sec. to 4 min. in all programs.
The master valve will stay on during the delay. The controller auto-
maticallv enters the delav in seconds and minutes. For example, if you
key in 4, the controller enters 4 seconds.
To program a delay between stations:
1.
Turn the dial to any program (e.g., Program
1
2.
Press the zero (0) key.
3.
Press the Water Time key.
4.
Key in the desired delay time (e.g., 400 for 4 min).
5.
Press the Enter key.
NOTE: The delay applies to all stations in all programs.
EXAMPLE:
.
.
.’
To program a delay of 1 min. in
’
4
.
all programs, turn the dial to
l
.
any program, such as Program 1:
. .
.
The controller displays the delay time:
Using Advanced Features
-
CONTINUED
REMOVING DELAY TIME
To cancel a programmed delay time, program a delay time of zero (0).
EXAMPLE:
To remove any previously
programmed delay time,
turn the dial to any program
(e.g., Program 1):
.
PR,OGRAhl
The controller displays zero:
USING OPTIONS
Several special options are available, including:
l Running a single program
l Changing watering time to seconds and minutes
OPTION
l-RUNNING A SINGLE PROGRAM
This feature allows you to run a single program automatically according
to the position of the dial. The single program option 1 reads “On” in
the Option position.
NOTE: With option 1 on, if the dial is not in a program positional1
programs will operate concurrently.
Using Advanced Features
35
To Next Page
Loading...
Need help?
General
