39
OPERATION
Rear PTO Shaft
FIG. 39: A six-spline 1 3/81(35mm) PTO shaft, 1, is pro-
vided at rear of Tractor to provide power for mounted and
other PTO driven equipment as required.
A protective cover is positioned over shaft splines when
not in use.
Normal rear PTO shaft operating speed of 540 rpm is
attained at 2532 engine rpm.
IMPORTANT:When rear PTO is used with three-point
mounted equipment, it may be necessary
to remove drawbar, 2, at rear of Tractor.
Some types of mounted equipment, when
lowered, may allow PTO shaft to contact
drawbar.
FIG. 40: Implement drive shaft shown connected to
Tractor rear PTO shaft.
CAUTION: Make sure all PTO shields are
installed on Tractor and equipment. Before
cleaning or adjusting Tractor or PTO driven
machine, SHUT OFF ENGINE AND DISEN-
GAGE PTO.
Mid PTO Shaft
FIG. 41: Mid PTO, 1, is forward-facing shaft located at
underside of Tractor. The mid PTO is used to operate cer-
tain mid or front-mounted implements. A1"(25.4mm) fif-
teen spline shaft is used.
Mid PTO cover must be installed when use of mid PTO is
not required.
2000 rpm @ 2476 engine rpm
CAUTION: Make sure all PTO shields are
installed on Tractor and equipment. Before
cleaning or adjusting Tractor or any PTO driv-
en machine, SHUT OFF ENGINE AND DISEN-
GAGE PTO.
FIG. 39
FIG. 40
FIG. 41
To Next Page
