9
SAFETY
shift the loaded tractor.
(7) Use ramps with the same or better specifications
mentioned below. When the machine is equ-
ipped with attachments other than those includ-
ed in the specifications mentioned below, ask
your Iseki dealer for advice.
Specifications of the ramps
• Length
more than 4 times the height of the platform of the truck
• Width (effective width) more than 35 cm
• Capacity (one ramp) more than 1700 kg
• Ramps should have anti-skid surfaces
(8) Hook the ramps securely on the platform of the
tractor with the top of the ramp level with the
platform.
(9) Always prepare for even the worst, by never
allowing other persons near the tractor.
(10) Drive the tractor carefully at the moment the
tractor moves from the ramps onto the platform,
for it changes angle abruptly.
U DURING OPERATION
(1) During operation, never allow other persons in
the vicinity of the tractor, because the tractor
itself or flung pieces may cause injury.
(2) Pay attention to safety around the tractor to av-
oid injury to bystanders or damage to property.
Especially when operating with other persons,
use the horn to warn them.
(3) When crossing a ditch or a levee or when pass-
ing through soft land, drive the tractor slowly
and straight so that it does not slip or turn over.
(4) Do not touch dangerous parts such as rotating
parts, moving pars, hot parts (muffler, radiator,
or engine, etc.), or electric parts (battery termi-
nals and other live parts), or you may be injured
seriously.
(5) If you use a trailer, use a proper one which suits
your tractor. Using an improper trailer may
cause serious accidents. Never attempt to haul
beyond the tractor’s capacity. If you have a
more than 4 times
the height of the platform (h)
h
To Next Page
Loading...
