82
TXG23
PRE-DELIVERY
K Check that engine oil level is correct.
K Check that coolant level is correct.
K Check fan belt tension, 10mm deflection, when sub-
jected to a force of thumb pressure.
K Check that transmission oil level is correct.
K Install a sufficient amount of No. 2 diesel fuel to com-
plete pre-delivery service.
K Ensure clean and tight cable connections at battery.
Battery must be securely mounted.
K Check air cleaner, element, hoses and clamps for cor-
rect installation.
K Check brake and clutch pedal linkage for correct free-
travel.
K Check steering, brake and clutch linkage cotter pins
and lock nuts for secure installation.
K Check filter element and, all connections and clamps
for hydraulic pump and filter.
K On 4-WD models, check oil level in front drive axle.
Place fuel filter shutoff valve in the "ON" position. Take
up position in operator's seat and engage parking
brake.
K Place all shift levers in neutral and then depress clutch
pedal.
K Place rear PTO and mid PTO selector levers in neu-
tral.
NOTE: Engine will not start unless range shift lever is
selected to neutral, rear PTO, and mid PTO selector
levers are in neutral.
K Set throttle lever at half to full throttle and turn main
switch counterclockwise 5-10 seconds until glow indi-
cator glows red.
K Turn main switch clockwise to "ON. " Oil pressure and
alternator warning lights will illuminate. Hold in "on"
position 1-2 seconds.
K Turn main switch to "Start" to crank the engine.
Release key to "ON" position the moment engine
starts. Check that warning lights go out.
K Allow engine to warm up to operating temperature at
about 1500rpm.
K Operate Tractor to confirm it operates smoothly at all
speeds including four-wheel drive (if so equipped).
K Operate PTO to see that it functions properly.
K Check that all lights and instruments operate properly.
K Check brakes for balanced operation.
K Check warm engine low idle speed, 1250-1300 rpm.
K Check warm engine high idle speed, 2760-2860 rpm.
K Set throttle lever at idle, shut off engine and check
Tractor for coolant, lubricating oil or fuel leaks.
K Check that safety start system functions correctly.
K Lubricate all fittings.
K Check tire inflation pressures.
K Check front wheel toe-in.
K Test anti-freeze to see that it is adequate for local cli-
mate conditions.
NOTE: Factory fill is set to -34˚ C .
K Check to see that all safety decals and safety switches
are in place.
K Clean and polish sheet metal as necessary.
K Fill fuel tank to prevent moisture accumulation.
K Review this Operator's Manual with the customer
when delivering or demonstrating Tractor.
To Next Page
