ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
e.
Support oil pan and remove thirty screws (5) securing oil pan. Remove oil pan (6) and gasket (6).
Discard gasket.
f.
If not removed, remove drain plug (8) and gasket (9).
3-17.2. Inspection.
a.
Inspect dipstick (1, FIGURE 3-40) for legibility. Replace if damaged.
b.
Inspect gasket (2) for deterioration and replace as necessary.
c.
Inspect oil pan (6 for cracks, dents, or other damage. Replace if damaged.
3-17.3. Installation.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
Wipe crankcase flange and oil pan flange and remove any traces of oil pan gasket or liquid
gasket.
Apply an even coat of sealing compound (FORMAGASKET2) to crankcase flange.
Affix new gasket (7, FIGURE 3-40) to crankcase flange.
Remove screw (3) and washer (4) securing tube.
Position oil pan (6) and install all thirty screws (5) hand-tight. Tighten screws to 72 in-lbs (8.1 Nm)
starting at point ‘A’ and ‘B’ alternately and work in a counterclockwise direction from each of these
points until all thirty screws are tightened.
Install screw (3) and washer (4) secunig tube. Tighten to 168 in-lbs (19 Nm).
Install oil drain plug (8) with new gasket (9).
Install dipstick (1) and new gasket (2).
Connect PCV hose.
Service lubrication system, refer to end item maintenance manual.
Operate engine and check for leaks.
3-74
Change 2
To Next Page
Loading...
Need help?
General
