ITech IT-M3140 Series - Page 46

Getting Started
Turning the POWER Switch On
Check that the power cord is connected properly.
Flip the POWER switch to the ( | ) side to turn the instrument on. The front panel
display will light up after a few seconds. It may take about 30 seconds or so for
the power supply to initialize before it is ready for use.
If a self-test error occurs, an error message will be displayed in the front panel.
Press the [Esc] button to try to clear the current fault status. The user can also
restart the instrument to try to clear the fault status. Wait until the power is
turned off and then start again. If the problem still cannot be solved after restart-
ing, please contact the ITECH engineer. Common error messages are shown in
the following table:
Error Messages Description
Cal User Data Lose User calibration information is lost.
Cal Factory Data Lose Factory calibration information is
lost.
ERROR SYSTEM DATA OVER Illegal system data.
ERROR SYSTEM System data setting failed.
ERROR SOURCE DATA OVER Illegal source data.
ERROR CONFIG DATA OVER Illegal config data.
ERROR SOURCE Source data setting failed.
ERROR CONFIG Config data setting failed.
The instrument takes approximately 30 seconds to initialize before it is ready
for use.
Copyright © Itech Electronic Co., Ltd.
35