Inspection and Installation
and Options, and the detailed operation please refer to the user manual of your
purchased mount kit.
2.4 Connecting the Power Cord
Precautions
To prevent electric shock and damage to the instrument, please observe the
following precautions.
• The power cords supplied with this product is certified for safety. In case
the supplied lines assembly needs to be replaced, or an extension lines
must be added, be sure that it can meet the required power ratings of
this product. Any misuse voids the warranty of this product.
• Before connecting power cord, be sure to confirm that the power voltage
matches with the supply voltage.
• Before connecting power cord, be sure to switch off the instrument.
Power switch is in Off position.
• To avoid fire or electric shock, make sure to use the power cord supplied
by ITECH.
• Do not use an extended power cord without protective grounding,
otherwise the protection function will fail.
• Be sure to connect the main power socket to the power outlet with
protective grounding. Do not use terminal board without protective
grounding.
• The instrument rear panel provides a separate screw used for chassis
ground. Please make proper connections. In the event of a failure, not
grouding properly may result in personal injury or death due to electric
shock.
Safety agency requirements dictate that there must be a way to
physically disconnect the AC mains cable from the unit. A disconnect
device, either a switch or circuit breaker must be provided in the final
installation. The disconnect device must be close to the equipment, be
easily accessible, and be marked as the disconnect device for this
equipment.
Copyright © Itech Electronic Co., Ltd.
18
To Next Page
Loading...
Need help?
General
