Inspection and Installation
• Before connecting test cables, be sure to switch off the power supply.
Power switch is in Off position, otherwise touching the output terminals
on the rear panel may result in personal injury or death due to electric
shock.
• To avoid electrical shock, before testing, please make sure the rating
values of the testing cables, and do not measure the current that higher
than the rating value. All test cables shall be capable of withstanding the
maximum short circuit output current of the power supply without
causing overheat.
• If several loads are provided, each pair of load wires shall safely
withstand the rated short circuit output current of the power supply under
full load.
• To avoid battery short circuit, be sure to check that the test line end is
not connected when connecting or disassembling the test line. When the
test line end is connected with battery, short circuit may cause severe
accident.
• During wiring, check that the anode and cathode of the test lines are
properly and tightly connected; anode ON and cathode OFF are
prohibited.
• If you need to pull out the green output terminal, please lift it up and pull
it out, otherwise it will damage the instrument.
Specification
Test cables are not standard accessories for the instrument. Please select
optional red and black test cables for individual sales based on the maximum
current value. For specifications of test cables and maximum current values,
refer toA.1 Specifications of Red and Black Test Cables for more information.
Connecting the DUT (Local Measurement)
The connection diagram and steps of local measurement are as follows:
Copyright © Itech Electronic Co., Ltd.
21
To Next Page
Loading...
Need help?
General
