Advanced Function
2. Rotate the knob and select Batt Emulator. Press [Enter] key and enter the
battery emulation function setting page.
3. Rotate the knob to select running battery emulation file (Run), recalling bat-
tery emulation file (Recall) and editing battery emulation file (Edit) in
successive.
Run Recall Edit
4. Select different functions for setting. For details, refer to the introduction of
specific operation.
Edit battery emulation file
1. In the setting interface of battery emulation function, select Edit, and enter
the battery emulation file editing menu.
2. At first, select the number of file to be edited. A maximum of 10 battery emu-
lation files can be edited in this instrument.
Edit Emul = 1/10
3. Edit the following parameters of this battery emulation file in successive.
Press [Enter] key to confirm setting.
1: Cell Properties
2: Parallel =1
3: Series =1
4: I_Limit + = 2.00A
5: I_Limit – = –2.00A
6: - -EXIT- -
• Cell Properties: Set the battery properties, including full-state voltage val-
ue, empty-state voltage value, internal resistance value and capacity val-
ue. The user can conduct setting based on battery specifications to be
emulated.
• Parallel: This function can emulate the state of several batteries in paral-
lel connection. For example, when “2” is set, the battery emulated in the
instrument is a battery group composed of two batteries in parallel
connection.
• Serial: This function can emulate the state of several batteries in serial
connection. For example, when “2” is set, the battery emulated in the in-
strument is a battery group composed of two batteries in serial
connection.
Copyright © Itech Electronic Co., Ltd.
60
To Next Page
Loading...
Need help?
General
