Basic Operation
Category
Parameter Initial Value
Voltage setting under AUTO
mode: Vs
Rated voltage of the
instrument
Current setting under AUTO
mode: Is
0A
Power setting under AUTO
mode: Ps
0W
Resistance setting under AU-
TO mode: Rs
Rated maximum resist-
ance value of the
instrument
On/Off state Off
Config
menu(Load
mode)
Operation mode CC
I-Rise Slope 0.1A/ms
I-Fall Slope 0.1A/ms
Von mode Latch
Von level 0V
On Delay/Off Delay 0s
• Last: Indicates when powered on, the instrument will remain the same
parameter settings and output status as last time you powered off the
instrument.
• Last+Off: Indicates when powered on, the instrument will remain the
same settings as last time you powered off the instrument, but the output
status is Off.
4. After the parameter settings are complete, press [Enter].
For example, Last is selected, and the voltage value is set to 20V. After the
instrument is powered off and then powered on, the voltage displayed on the
interface is 20V.
6.7 Sense Function (Sense)
This menu item is used to switch the power system to local measurement or re-
mote sensing.
The IT6000B series power system supports two connection methods: Local
measurement and Remote sensing. The remote sensing is used for maximizing
Copyright © Itech Electronic Co., Ltd.
147
To Next Page
Loading...
Need help?
General
