Basic Operation
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• Display: Display the current regenerative power value.
• Clear: Clear the total current regenerative power value and exit the
function.
4. After the parameter settings are complete, press [Enter].
If you select Display and press [Enter] key, the interface will display the
voltage, frequency and power value. Press [Esc] key twice to exit the
function.
6.17 Display Loading Time (Disp on timer)
The user can turn the loading time display on or off base on personal
requirement.
The setting procedures are as follows:
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the Disp on timer and
press [Enter]。
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• On: indicates the display is on.
• Off: indicates the beeper is off.
4. After the parameter settings are complete, press [Enter].
6.18 System Upgrade
The IT6000B series power system supports the upgrade of the system version.
System upgrade includes the following two methods:
• During the start-up period after the instrument is powered on, through the
USB interface on the front panel, select the system upgrading files in the
memory device (USB flash drive) for upgrading.
• The user can access to the Web service programs in the instrument by the
Web browser on PC for upgrading operation.
Copyright © Itech Electronic Co., Ltd.
189
To Next Page
Loading...
Need help?
General
