ITech IT6513C Manual

Wave Operation Command
Copyright© Itech Electronics Co., Ltd. 68
SEQuence[:STEP]:SLOPe
This command is used to edit the slope of a specified step of the wave
file.
Command syntax
SEQuence[:STEP]:SLOPe <NR1>,MINimum|MAXimum|NRf
Arguments
<NR1>,MINimum|MAXimum|NRf
Unit
s
Example
SEQ:SLOP 1,4
Query syntax
SEQuence[:STEP]:SLOPe? <NR1>,[MINimum|MAXimum]
Returns
NRf
SEQuence:SAVe
This command is used to save the wave file.
Command syntax
SEQuence:SAVe <NR1>
Arguments
<1~100>
Example
SEQ:SAV 1

ITech IT6513C Specifications

General

Brand	ITech
Model	IT6513C
Category	Power Supply
Language	English