To Next Page

To Previous Page

Configuration Commands

Example

conf:prot:curr:peak:mod imm

Query syntax

CONFig:PROTect:CURRent:PEAK:MODe?

CONFig:BNC[:PORT][:FUNCtion]

This command is used to set the function of BNC terminal. The command

function is the same as BNC-Set in the instrument panel menu.

Command syntax

CONFig:BNC[:PORT][:FUNCtion]

Parameters

I-TRigger|I-RI|O-PHase|O-ON

Example

CONF:BNC I-RI

Query syntax

CONFig:BNC[:PORT][:FUNCtion]?

CONFig:DIMMer:MODe

The command is used to configure the phase dimming mode: leading/trailing

edge dimming. This command function is equivalent to Dimmer in the

instrument panel menu.

Command syntax

CONFig:DIMMer:MODe

Parameters

LEADingedge|TRAilingedge|OFF

Example

conf:dimm:mod lead

Query syntax

CONFig:DIMMer:MODe?

CONFig:LIST:STARt:MODe

This command is used to set the mode that LIST starts to run. The command

function is equivalent to the configuration menu to set List-Set.

ITech IT7324 Programming Guide

Other manuals for ITech IT7324