Measurement Commands
Copyright © Itech Electronic Co., Ltd. 35
Returns
<NR2>
FETCh[:SCALar]:POWer[:AC]:PFACtor?
This command is used to read the most recent power factor reading.
Command syntax
FETCh[:SCALar]:POWer[:AC]:PFACtor?
Returns
<NR2>
FETCh[:SCALar]:FREQuency?
This command is used to read the most recent frequency reading.
Command syntax
FETCh[:SCALar]:FREQuency?
Returns
<NR2>
FETCh[:SCALar]:CURRent[:AC]:PEAK?
This command is used to read the most recent peak current reading.
Command syntax
FETCh[:SCALar]:CURRent[:AC]:PEAK?
Returns
<NR2>
FETCh[:SCALar]:CURRent[:AC]:PEAK:MAXimum?
This command is used to read the most recent maximum peak current reading.
Command syntax
FETCh[:SCALar]:CURRent[:AC]:PEAK:MAXimum?
Returns
<NR2>
MEASure[:SCALar]:VOLTage[:AC]?
This command is used to read the current voltage output value.
To Next Page
Loading...
