To Next Page

To Previous Page

Calibration Commands

Chapter14 Calibration Commands

CALibrate:SECure:[STATe]

This command is used to set the power protection mode to be valid or invalid

during calibration.

Command syntax

CALibrate:SECure:[STATe] {<ON|OFF>,[<password>]}

Parameters

0|1|ON|OFF,

Example

CAL:SEC 1; CAL:SEC OFF

Query syntax

CALibrate:SECure:STATe?

Parameters

None

CALibrate:SAVe

This command is used to save the calibration coefficients in non-volatile

memory.

Command syntax

CALibrate:SAVe

Parameters

None

CALibrate:VOLTage:LEVel

The command is used to specify the voltage calibration point. P1, P2, P3, P4

calibration points must be sequentially calibrated.

Command syntax

CALibrate:VOLTage:LEVel <point>

Parameters

P1|P2|P3|P4

ITech IT7324 Programming Guide

Other manuals for ITech IT7324