ITech IT7324 Programming Guide

Phase Control Commands
Copyright © Itech Electronic Co., Ltd. 25
Chapter5 Phase Control Commands
[SOURce:]PHASe:STARt
This command is used to set the starting phase angle of the power supply.
Command syntax
[SOURce:]PHASe:STARt
Parameters
MINimum|MAXimum|DEFault|Float
Example
phas:star 80
Query syntax
[SOURce:]PHASe:STARt?
[SOURce:]PHASe:END
This command is used to set the termination phase angle of the power supply.
Command syntax
[SOURce:]PHASe:END
Parameters
MINimum|MAXimum|DEFault|Float
Example
phas:end 80
Query syntax
[SOURce:]PHASe:END?
[SOURce:]DIMMer[:PHASe]
This command is used to set the phase angle of the phase dimming function.
Command syntax
[SOURce:]DIMMer[:PHASe]
Parameters
MINimum|MAXimum|DEFault|Float

ITech IT7324 Specifications

General

Brand	ITech
Model	IT7324
Category	Power Supply
Language	English