To Next Page

To Previous Page

TRACe Subsystem Commands

Returns

{<NR3>}

The following is an example of how to use the commands of the Trace

subsystem:

1. TRACe:FREE?

This command is executed to confirm the current buffer status.

2. TRACe:POINts

This command is executed to set the size of the buffer.

3. TRACe:FEED

This command is executed to set the type of reading source saved to the

buffer, such as VOLTage.

4. TRACe:FEED:CONTrol

This command is executed to set the save mode of the buffer, such as

NEXT.

5. TRIGger[:IMMediate]

This command is executed to trigger the IT7300 instrument to enter data

storage status.

6. TRACe:DATA?

This command is executed to read the data stored in the buffer to the PC

interface.

ITech IT7324 Programming Guide

Other manuals for ITech IT7324