Itho Daalderop Smartboiler - M3.3. Service

M3.2.3. NIGHT HH_MM
| Factory setting 23:30 | Min. 00:00 | Max. 23:59 | +/- 00:01 |
2330
night
The LED indicator flashes yellow rapidly.
Setup or adjustment of night mode start time.
The stored water is only heated during night mode. In night mode
the appliance control unit automatically determines when to start
heating to obtain the correct stored water temperature at the end of
the night mode.
Night mode stops when day mode starts.
M3.2.4. SUMME RTIME
| Factory setting OFF | OFF/ON | +/- |
off
summe
The LED indicator flashes yellow rapidly.
Summertime correction setup.
The time is not automatically adjusted at the start of daylight saving
time or winter time. You will need to correct the daylight saving time
and winter time manually.
Correct time is important for functions with a start time and stop
time. Failure to set the correct time means that certain functions
will not start or stop at the correct time.
● OFF - The function is disabled (winter time).
● ON - The function is enabled (summertime).
5.12. M3.3. SERVICE
The following parameters can be set in the submenu:
SERVICE
M3.3.1. TMAX °C
M3.3.2. TMIN °C
M3.3.3. ERROR RESET
Example parameter:
0
ERROR
The LED indicator lights up continuously in yellow.
Select setting
●
Switch between the displayed settings by pressing the △ or ▽
button.
●
Pressing the ↺ button returns the screen to the previous
menu.
●
Press the ✓ button to open the selected setting.
Edit parameter
●
Change the setting by pressing or holding the △ or ▽ button.
●
Cancel the setting by pressing the ↺ button.
●
Confirm the setting by pressing the ✓ button.
29