3 Set Up A New FC300
Set Up A New FC300
Note: LXE recommends that installation or removal of accessories be performed on a clean, well-lit
surface. When necessary, protect the work surface, the FC300, and components from electrostatic
discharge.
While the FC300 is in a Hazardous Location DO NOT:
● Connect an external power source to the FC300.
● Connect a USB device or audio jack to the FC300.
● Connect the Car Power Adapter to the I/O connector at the base of the FC300.
● Remove or install a battery pack in the FC300.
● Connect a tethered scanner to the FC300.
● Place the FC300 in a powered cradle.
Hardware Setup
1. Connect accessories.
2. Connect cables.
3. Insert/connect a fully charged battery
4. Press the Power key.
Software Setup
Prerequisite: Hardware setup is complete.
1. Calibrate Touch screen
2. Set Date and Time Zone
3. Set Power Schemes Timers
4. Set Speaker Volume
5. Pair Bluetooth devices
6. Save changed settings to the registry
WH-FC300USER-001 FC300 User Guide
For Review - Do Not Distribute - LXE Confidential
To Next Page
Loading...
Need help?
General