ITRON Gen 5 500W ERT - Page 18

5. If your cable tie gun is equipped with a dial to set the tightening pressure, set the pressure
to ensure that the cable tie is secure on the lead wire. After installation, the cable tie must
not move on the register or secondary lead wire.
6. If your cable tie gun does not have a clipping feature, remove the cable tie from the cable
tie gun. Using a side cutter pliers, clip the excess cable tie.
7. Place the cable connection into the 500WERTModule housing with the cable ties to the
inside.
Gen5 500WERTModule Remote Installation Guide 3 Setting up and Installing
December 5, 2022 LDI-0343 REV002 Itron, Inc. Page 18 of 48