ITRON Gen 5 500W ERT - Remote Mounting Procedures

5. Completely tighten all screws evenly in an alternating fashion.
Remote Mounting the 500WERTModule
1. Connect the 500WERTModule to the register as described in Initializing and Connecting
on page 12.
2. Using a backplate, create a template by drilling through a backplate lug slot to mark the
position of the screw. Use the drilled backplate as your mounting template.
The arrow on the 500WERTModule must point up when installation is complete.
Gen5 500WERTModule Remote Installation Guide 3 Setting up and Installing
December 5, 2022 LDI-0343 REV002 Itron, Inc. Page 20 of 48