ITRON Gen 5 500W ERT - Splice Tube Immersion

4. The connector is properly crimped when the top of the moveable yellow center (1) is flush
with the top of the connector body (2).
Warning! Crimping the connector forces some sealant out of connector. The sealant protects the
inside of the connector against insects, moisture, and other contaminants. The sealant may cause
minor eye and skin irritation. Avoid eye contact. Avoid prolonged or repeated skin contact. Contact
Itron Support for Safety Data Sheets (SDS).
5. After the 500WERTModule to register or meter wire connections are completed, arrange
the connectors in a single file.
6. Insert the connectors and wires into the splice tube until the connectors and wires are
completely immersed in the non-conductive gel material.
Gen5 500WERTModule Remote Installation Guide 4 Using Gel-cap Connections to Complete Wiring Connections
December 5, 2022 LDI-0343 REV002 Itron, Inc. Page 35 of 48