94
RESET_MEASUREMENT_DATA Reset of measurement data
START_MEASUREMENT Start measurement
STOP_MEASUREMENT Stop measurement
START_TRIGGERED_TESTS Start triggered tests
STOP_TRIGGERED_TESTS Stop triggered tests
END_OF_DATA_SAVING End of current data saving
LOAD_PROFILE_RESET Load profile reset
PASSWORD RESTORATION Password restoration
INDEX_CLOCK_LOSS Default clock loss index
SUCCESSFUL COMMUNICATION Successful communication
Note Event Comment
1 PARAMETERS_SAVING Recorded each time new configuration parameters have
been programmed into the meter.
2 AC_FAIL_APPEARANCE
AC_FAIL_DISAPPEARANCE
Recorded when a micro power failure (<=1 second) is
detected by the meter, at the same time the state of power
supply backup is checked.
3 PWR_FAIL_APPEARANCE Recorded when the meter cut calculation reaches the
lower threshold, all meter data is then saved.
10.2. Alarm descriptions
The following table contains a list of alarms (these may change due to meter firmware revision):
Non-fatal alarm Type Description
WATCHDOG ACTIVITY Trapped Watchdog
(see note 1 below)
EXTERNAL CLOCK INCOHERENCE Trapped Meter clock programming error
(see note 2 below)
CONFIGURATION INCOHERENCE Trapped Incoherence of configuration parameters
(see note 3 below)
NON VOLATILE MEMORY NON FATAL
ERROR
Trapped Checksum error in Flash memory
(see note 1 below)
PROGRAMMING INCOHERENCE Trapped Incoherence of parameters programmed
(see note 4 below)
COVER OPENING Trapped Detection of abnormal use of cover
TERMINAL COVER OPENING Trapped Detection of abnormal use of terminal cover
NO INTERNAL CONSUMPTION Self-healing No internal energy consumed for more than n days
NO EXTERNAL CONSUMPTION Self-healing
No external energy (pulse inputs) consumed for more
than n days
ZERO SEQUENCE U Self-healing
Vectoriel sum of U vectors greater than prog.
Threshold
ZERO SEQUENCE I Self-healing
Vectoriel sum of I vectors greater than prog. Threshold
To Next Page
Loading...
Need help?
General
