27
ECOROLL
The driving conditions that determine activation of EcoRoll are defined by the manufacturer. They cannot be changed, and
take the following parameters into consideration:
▪ Slope and curve radius of the road
▪ Vehicle acceleration
▪ Engine torque
▪ Gear engaged before activation of EcoRoll
If the conditions for maintaining the active EcoRoll function no longer apply, it will be deactivated, and the most suitable gear
will be engaged.
The driver will be informed that the gear has been selected, because the engaged gear will be shown on the display instead of
the letter “E”.
The same display will be shown when the driver:
▪ engages the intarder, the engine brake, or the brake pedal (service brake)
▪ engages the gas pedal
▪ switches gears using the right-hand stalk switch, presses the “D” button on the dashboard (Drive), or exits “AUTO”
mode.
▪ switches off the cruise control
General specifications: When EcoRoll is active, the vehicle is idling. The engine brake or a
torque requested are activated at a time-delay, since the gear must be engaged once
again. Failure to observe these specifications in whole or in part may result in serious
damage to the vehicle.
To Next Page
Loading...
