44
The “Lane departure warning system” warns inattentive or tired drivers of an upcoming, accidental lane change, and signals
when the lane boundaries are crossed. The system uses the camera / sensor (1) in the middle of the dashboard behind the
windscreen.
For the system to function properly, the windscreen of the vehicle must be clean. If there is a layer of ice or frost on it,
please remove this layer to clear the field of view of the sensor (2).
The following warning signals will sound above 55 km/h:
▪ Radio becomes quieter (if provided)
▪ Intermittent warning buzzer on the instrument panel (or activated in the speaker, if provided)
▪ Symbol on the instrument panel flashes (3)
Activation / deactivation
The system is always active when the vehicle is started. The (4) button can be used to deactivate the LDWS system. Then the
(3) and (6) control lights switch on. The pop-up switches off.
Malfunction
In case of a fault, the (6) symbol, the yellow control light (3) (in addition to a pop-up notification on the dashboard showing
“LDWS not available” and the yellow warning light (7) will be continuously illuminated on the instrument panel.
LANE DEPARTURE WARNING SYSTEM (LDWS)
General hazards, general specifications
If there is very low contrast on the roadway markings, direct sunlight hitting the camera,
worn and/or missing markings on the edge of the roadway, or poor visibility, the
monitoring and alarm signals may not function. If the specification is not complied with,
there is a significant health risk and the risk of serious vehicle damage
4
To Next Page
Loading...
