Iveco WAY RANGE - Anti-Roll-Back (Arb; Hill Holder)

39
Anti-Roll-Back (Hill Holder, dependent on equipment):
This function prevents the vehicle from rolling backwards on hills. If this function is switched on, the
maximum pressure specified by the driver is maintained when the vehicle is stopped, as long as the brake
pedal is depressed even slightly.
Operation:
▪ Press the relevant button (9) on the keypad to activate the function.
▪ Activating the function will maintain the brake pressure set by the driver while the vehicle is at a
standstill, as long as the brake pedal is depressed even slightly
▪ After the brake pedal is fully released, the pressure is maintained for approx. 2 seconds so that the
driver can press the gas pedal again and restart it without the vehicle rolling backwards
▪ When the hand brake is activated, the uphill driving function will be switched off automatically
ANTI-ROLL-BACK (ARB / HILL HOLDER)
NOTE: If the ARB is activated on flat surfaces or on hills (unnecessarily), this will result in
excessive wear!