41
Operation
▪ Key is in the slot.
▪ Pressing the ENGINE START / STOP button on the instrument panel for 1 s switches on the instrument panel and the
control lights (1), (2) and (3) will be illuminated.
▪ If the control light (1) remains activated, the ECAS is not in driving position (the vehicle has lifted or lowered the axle).
When the control light (1) switches off, ECAS is in driving position.
Description of the remote control
The remote control can be used to set and save the level of the springs.
1. Release for height adjustment of the front springs
2. Release for height adjustment of the rear springs
3. Saved level M1 (front and rear axle)
4. Saved level M2 (front and rear axle)
5. Self-levelling springs
6. Lifting
7. Lowering
A. Confirmation control light for release for height adjustment of the front springs
B. Confirmation control light for release for height adjustment of the rear springs.
AIR SUSPENSION
NOTE: The indicator lights (2) and (3) will only switch on if the vehicle has a lift axle.
Do not shut off the engine when the symbol (5) is switched on. If the symbol (4) is illuminated
while driving, stop the vehicle and remove the key from the slot; re-insert the key after
approximately seven seconds. If the symbol (4) does not switch off after approximately two
seconds, contact customer service.
To Next Page
Loading...
