Connecting the CNC computer
The transport lock
must not
be installed when
you connect the CNC computer to the machine.
Removing the transport protection
– on
page17
1. Switch on the machine at the main power switch.
2. Close the working chamber door.
3. Start the CNC computer.
4. Use the provided USB cable to connect a USB
port of the CNC computer to the USB port at the
connection panel of the machine.
5. Install the latest version of PrograMill CNC that is
released for the machine.
6. To determine the USB port number and con-
nect to the machine, select the depicted
icon in the Application settings view in PrograMill
CNC.
PrograMill CNC may try the following to connect
to the machine: If this is successful, the applic-
ation will display the port number beside the icon.
The machine references.
The machine will not reference if the
working chamber door is open.
7. If the working chamber door was open during the
previous step, close it. If the machine does not ref-
erence as a result, quit PrograMill CNC and
restart the application.
PrograMill Dry – Installing the machine
EN 21
Operating Instructions:PrograMill Dry
Version: 11/19/2020
To Next Page
Loading...
