Ivoclar digital PrograMill Dry - Default Chapter; Table of Contents

Table of contents
1 Welcome 4
About this document 4
Used symbols 4
Structure of safety notes 4
2 General safety instructions 5
3 Operating regulations 7
Intended use 7
Controlling the machine through software 7
Maintenance and cleaning 7
Spindle 7
Unattended operation 7
Transportation and storage 8
4 Machine overview 9
Front side of the machine 9
Connection panel 9
Working chamber door 9
Working chamber 10
Accessories container 10
Anti-soiling concept 11
CNC computer 11
Sound emission 11
Location of the identification plate & serial num-
ber 11
Axes 12
Linear axes 12
Rotational axes 12
Technical data 13
5 Installing the machine 14
Checking the scope of delivery 14
Choosing the installation site 15
Machine installation (schema) 16
Establishing the electric connection 17
Removing the transport protection 17
Installing the pneumatics 18
Overview compressed air regulator 18
Installing the pneumatic hose 19
Adjusting the air pressure with the compressed
air regulator 19
Installing the air extraction system 20
Requirements for the suction unit 20
Installing the suction unit 20
Connecting the CNC computer 21
6 Operation: Preparing jobs 22
Starting the machine 22
Starting the machine with a tool in the collet
chuck 22
Switching off the machine 23
Mounting and removing materials 23
Mounting discs in the working chamber 23
Managing tools 25
Inserting and exchanging tools 25
7 Operation: Processing jobs 27
Starting jobs 27
Aborting milling 27
Job interruptions and job abortions 28
How to proceed in case of a job interruption 28
How to proceed in case of a machine mal-
function 28
How to proceed in case of a tool breakage 28
How to proceed in case of a power failure 29
Emergency opening of the working chamber
door 29
8 Maintenance and do-it-yourself 31
Preventive maintenance 31
Where to get service? 31
Cleaning the working chamber 31
Cleaning the collet 32
Checking the compressed air regulator 34
Checking the water separator for condensate 34
Exchanging/ cleaning the contaminated filter
cartridge 34
Cleaning the housing 34
Exchanging the main fuse 35
Calibrating the axes 35
Replacing the tool magazine inserts 35
Updating the software and firmware 36
Updating the manufacturing software 36
Updating the firmware of the machine 36
Maintenance table 37
9 Disposal 39
Disposing of the machining residues 39
Disposing of the machine 39
10 Troubleshooting guide 40
Index 43
Operating Instructions:PrograMill Dry
Version: 11/19/2020
EN 3