EasyManuals Logo
Home>JAC>Automobile>J2

JAC J2 User Manual

JAC J2
243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #186 background imageLoading...
Page #186 background image
Maintenance Manual for J2 Sedan
Electronic Control System
of Engine
185
the throttle. The resistance measurement shall vary linearly following the opening of the throttle.
The measurement on 2# and 3# pins shall be on the contrary.
Note: While observing the variation of resistance, pay attention to observe for presence of high
resistance leap.
Operating
temperature:
-40 - 125 ;
6.
Dismantlement and
installation of
throttle
position sensor
1) Dismantlement
Disconnect the
wire harness
connector of
air
throttle position sensor.
Note: Be sure
that
the
ignition
switch
is
at
the
“Off” position.
Remove
the
screws
of
throttle position
sensor
and remove the sensor.
2) Installation
Be aware of following to install with steps contrary to dismantlement.
V
erify that
the
of
the
wire
harness connector
is
inserted securely
.
Tighten
self-tappin
g
screw.
IV
.
Crank
shaft
Position
Sensor
1.
Component
Description
The crankshaft position sensor is used to provide the engine speed information and crankshaft top
Fig. 4.3.07
Fig. 4.3.08

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JAC J2 and is the answer not in the manual?

JAC J2 Specifications

General IconGeneral
BrandJAC
ModelJ2
CategoryAutomobile
LanguageEnglish

Related product manuals