JAC J2 User Manual



Maintenance Manual for J2 Sedan
Service
27
17.
Inspection o
f Seat be
lt, Tuckle and Pre-tensioner
Attention:
■ The seat belt assembly
including retract
or and
other accessories (such a
s fixing
bolt, guide
rail device) should be inspected every time
after collision.
We suggest that you should replace seat belt assembly after collision, unless it is free of any damage
after slight impact.
And the
seat
belt
assembly
which
is not used
during
the accident should
also
be checked,
please
replace any damaged seat belt
assembly.
In case a front collision which activates both driver and passenger’s airbags happens, the seat belt
pre-tensioner should be replaced, even though the seat belt
is not used
at all.
■
If any
component
of seat
belt asse
mbly has
problems,
please
do not
repair it,
but replace
the seat
belt assembly.
■
In case
the sea
t belt
is brok
en, worn or
damaged,
don’t repa
ir but
replace the
seat be
lt asse
mbly.
■ Be
sure
not to lubricate the lock
tongue
and
snap ring.
■ Use
original
seat belt
assembly
of JAC.
■
Check
whether
the
anchorage
is
loose.
■
Check
whether
the
seat
belt
is
damage
d.
■ Check whether the motion of retractor is
flexible.
■
While
the sn
ap ring
open,
check w
hether th
e snap
ring and
lock ton
gue f
unction
normally.
VII.
Maintenance
Data
1.
Tightening
Torque
of
Standard
Parts
Tightening Torque List of Standard Parts
Torque (N·m)
Nominal Diameter of
Thread
Pitch
Head
mark
4
Head
mark
7
M5 0.8 3-4 5-6
M6 1.0 5-6 9-11
M8 1.25 12-15
20-25
M10 1.25 25-30 30-50
M12 1.25 35-45
60-80
M14 1.5 75-85 120-140
M16 1.5 110-130 180-210
M18 1.5 160-180 260-300
M20 1.5 220-250 360-420
M22 1.5 290-330
480-550
M24 1.5 370-420 610-700

JAC J2 Specifications

General

Brand	JAC
Model	J2
Category	Automobile
Language	English