JAC J2 - Page 30



Maintenance Manual for J2 Sedan
Service
28
Attention:
■
Tightening
torques
listed
above
are
the sta
ndard
values
which
are
applicable
for followi
ng
conditions:
a. Steel,
plating
nuts and bolts.
b.
Plated
steel
plain
washers.
c.
All
the
dry
nuts, bolts
and
gaskets.
■ The
torques
listed above are not applicable
for
following
conditions:
a.
When
the com
ponent i
s to
be tightene
d wit
h spring
or tooth
washer;
b.
Tightening
of
the
plastic
parts.
c. Self-tapping screw or self-locking nut.
d. Oiled
thread
and surface.
■
In
following
conditions,
the
torques
listed
above
should
be
correspondin
gly re
duced:
a.
if a
spring w
asher
is us
ed,
the torque
should
be re
duced
to 85%.
b. If bolt surface is
coated w
ith oil, the torque
should
be reduced to 85%.