JAC J2 User Manual



Maintenance Manual for J2 Sedan
Overview
6
Section III
Lifting, Protection and Towing
of
Vehicle
I.
Lifting
of
Ve
hicle
1.
Vehicle’s
Supporting
Points
The positions of vehicle’s supporting points are shown in figure below.
Attention:


Don’t lift the vehicle by using the point other than those specified; otherwise vehicle body
may be damaged.
Positions of Vehicle’s Supporting Points
2.
Operation
of
Lifter
The lifter should be operated strictly
in accordance with the specifications of manufacturer
.
Caution:


The operation against the specifications may cause damage of vehicle or personnel injury or
even death.
II. Protection
of
Vehic
le
1.
Appearance
Protection
Be sure to use the four protection appliances including seat cover, steering wheel cover, gearshift
lever cover, and foot mat before any operation. A protective pad must be applied on the fenders
when engin
e hood is open
ed for inspection
.
2.
Preventive
Measures
before
Welding
Since electrical components are installed on the vehicle, the following procedures must be carried
out in order
to avoid too large
current through such components in welding:
1)
Turn
ignition switch
to
“OFF”
position;
2)
Disconnect
negative
pole
of
battery;
3)
Ground the
welding
equipme
nt carefu
lly at
a point
nearby
the weldi
ng area
;
4)
Cover other exposed equipment around the
welding
area to prevent solders from spl
ashing o
n.
Supporting point


JAC J2 Specifications

General

Brand	JAC
Model	J2
Category	Automobile
Language	English