Maintenance Manual for J2 Sedan
Electronic Control System
217
es To
Check if the voltage between Pin 2# of phase sensor and the negative
pole of power source is about 9.9V.
Yes
5
connecting to Pin 2# of phase
sensor connector to
Pin 42# of ECU is open or short to power source or ground.
es
s
6
if
of
is
Fault code: P0341 “the contact of phase sensor is not good”
step
Connect the diagnosis device and adapter, and turn the ignition switch
es
Unplug the phase sensor connector on the harness, and check if the
voltage between Pins 3# and 1# of this connector is about 12V by the
the harness
Check if the circuit connecting Pin 3# of phase sensor to Pin 87# of
main relay is open or short to
.
es To
Check if the voltage between Pin 2# of phase sensor and the negative
pole of power source is about 9.9V.
Yes
5
connecting to Pin 2# of phase
sensor connector to
Pin 42# of ECU is open or short to power source or ground.
es
s
Fault code: P0342 “the phase sensor is short to ground”
1
Connect the diagnosis device and adapter, and turn the ignition switch
Next step
es To
Unplug the phase sensor connector on the harness, and check if the
voltage between Pins 3# and 1# of this connector is about 12V by the
Yes
3
Check if the circuit connecting Pin 3# of phase sensor to Pin 87# of
main relay is open or short to
.
To Next Page
Loading...
Need help?
General
