JAC J2 - Page 47



Maintenance Manual for J2 Sedan
Mechanical Part of Engine
46
③

Disconnect the locking
clamp of intake hose, and
then take
off upper cover and intake hose.
■ Tightening
torque:
6-9
N·m
④

Dismount
the fix
ing bolt
of air
filter ba
se, a
nd
then take down the base.
■
Tightening
torque:
8-12
N·m
2)
Check
after
Dismantlement
Check whether there is any crack or wearing on the air duct assembly. If any, replace.
3) Installation
Install with steps contrary to dismantlement.
Attention:
■
Properly
mount every
joint
and
tighten the
clamp.
3.
Replacement
of
Air
Filter
element

1) Dismantlement
①

Loosen the lock
clips of
air cleaner
upper
cover and lift the upper cover.
Fig. 1.1.012
Fig. 1.1.011
Fig. 1.1.013
Fig. 1.1.010