English
Your mains electricity supply to the machine
must be protected as indicated below:
- North America: 15 A protection;
- Rest of the world: 16 A protection.
For machines equipped with a variable speed
drive, it is imperative that they be connected
to a junction box on a circuit fitted with a
300 mA RCD.
Note: Any problem resulting from any other
type of connection will not be covered under
warranty.
Before connecting your machine to the mains
supply and in order to prevent the motor from
burning out when it is switched on, it is
important to check that the mains supply
matches the machine specification (see
machine nameplate).
This machine complies with Machinery Directives 2006/42/EC, 2014/35/EU, 2014/30/EU and is CE-
marked as proof of this compliance.
Please familiarise yourself with the safety pictograms displayed on the machine:
This pictogram indicates a cut hazard. You will find it at the front of the machine
around the loaf positioning area (fig.9, n°32).
You will find the circuit diagram for the machine on the back of the electrical
enclosure door (fig.9, n°33).
This pictogram indicates an electrocution hazard. Please isolate the machine
before carrying out any work on it. You will find it at the back of the machine close
to the power cable and inside the machine on the electrical enclosure (fig.9, n°34).
This pictogram indicates a contact with moving parts hazard. You will find it near
the crumb tray (fig.9, n°31).
5.4 Commissioning:
Before commissioning, ensure that there are no extraneous objects interfering with the machine’s
moving parts.
For machine operation, please refer to the “Operation” chapter.
5.5 Danger:
If the user or the machine is in danger, use the emergency stop button to cut the power supply to the
machine.
To Next Page
Loading...
