English
D. Open the cover. Remove the 4 screws from the front table and withdraw it.
E. On the left-hand inner side, remove screw A securing the front frame link.
F. Lay the frame down forwards. Replace the blades on the rear frame (place something to
protect yourself on the front frame blades). Remove the locknuts on screws B (MRF – MRM –
MRQ). Remove the blade-tightening Allen screws B. Replace the blades, checking that they
locate correctly in the swing arm pins. Retighten the blades by tightening screws B, using the
blades remaining on the frame as a reference. Then tighten the nuts (machine fitted with
lubrication option).
In order not to distort the frame and avoid the risk of dangerous breakages, only replace 1 to 3
blades at a time alternating from left to right.
Resume the procedure from point E for the front frame and refit the front frame and the cover
sections.
Connect your machine to the mains supply; it is now ready.
Check that your approved agent has recorded his work in your service booklet in order to maintain
your 5-year warranty cover.
9 CONSUMABLES
When ordering spare parts, check with your approved agent which part is required based on the
spare parts catalogue issued by the manufacturer.
Always quote the machine serial number shown on the nameplate.
Your agent will place the orders with JAC.
9.1 List of CONSUMABLES
JAC KNIFE, 13 MM/0.5 MM + TEFLON
LOAF HOLDER SPRING PLASTIC RING
LOAF HOLDER SPRING STAINLESS STEEL RING
PHOTOELECTRIC CELL REFLECTIVE STRIP
To Next Page
Loading...
