Jackle tecMIG 450 - Overview Control Functions

tecMIG 450/600
Operating manual Page 34
24. Overview control functions
Functions MC 1 MC 2
Thyristor welding source ■ ■
Manual mode ■ ■
Automatic mode ■ ■
Wire feed rate tuning ■ ■
Material adjustment ■ ■
Welding power individual adjustable ■ ■
MIG mode ■ ■
TIG mode – with adjustable pre-flow time and slope-down time ■ ■
MMA mode – with adjustable Hotstart ■ ■
2-cycle, 4-cycle, spot welding ■ ■
Crater program ■
Backup function for user programs (100 pieces) ■
Gas test ■ ■
Wire feed in ■ ■
Cooling medium flow indicator ■
Cooling medium min flow adjustable ■
Welding power adjustable over material thickness, direct - step less ■ ■
Start speed (Sts) adjustable ■ ■
Burn back time (bUb) adjustable ■ ■
Gas post flow time (PoG) adjustable ■
Gas pre flow time (PrG) adjustable ■
Spot time (Spt) adjustable ■ ■
Welding choke adjustable ■
Welding choke predefined ■
Remote control function user adjustable ■
Welding cable length adjustable ■
Water pump ON/OFF ■
Machine type adjustable ■
Update for welding curves ■ ■
Control unit lock / unlock ■
Fan / water pump (if installed) controlled ■ ■
Display HOLD time adjustable ■ ■
Reset to factory settings ■ ■