07610-004-37-13-R
13
Before operating machine, verify:
1. Strainer is in place and clean.
2. Wash and rinse arms are screwed securely into place and end-caps are tight.
3. Wash and rinse arms rotate freely.
4. Chemical levels in chemical containers are correct.
1. Close door.
2. Turn machine on.
3. Machine will automatically begin to fill.
4. Once wash tub is filled, wait until wash temperature is at least 150 °F for HT and
120 °F for LT/LT-H before operating machine.
OPERATING INSTRUCTIONS
OPERATION
PREPARATION
FILLING THE
WASH TUB
LT and LT-H have combined
wash/rinse arms.
HT LT/LT-H
See Initial Fill section
for HT models.
To Next Page
Loading...
