07610-004-37-13-R
17
1. Remove rinse arms and place in sink with deliming solution (leave for amount of
time recommended by chemical supplier).
2. Replace rinse arms.
3. If the machine is full of water, close door, press power button, and allow the
machine to drain and shut-off.
4. Follow Filling the Wash Tub section of this manual.
5. Open door and add amount of deliming solution recommended by chemical
supplier.
6. Use cycle button to select Delime.
7. Close door and the machine will begin delime cycle. Cycle timer shows on right
display. LED on power button will turn green.
8. The machine will delime, drain, and rell. When cycle is complete right display
will turn off.
9. Wait ve minutes and inspect the machine. If the machine is not delimed,
run again.
10. When clean, use cycle button to select Normal.
11. Run two Normal cycles to remove residual deliming solution.
12. The machine is now ready for normal operation.
OPERATING INSTRUCTIONS
OPERATION
DELIMING
HT
If machine is equipped
with an SPS and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, call the
manufacturer.
150 °F
150 °F
299
150 °F
To Next Page
Loading...
