Jackson DishStar LT - Page 30

07610-004-37-13-R
23
1. Once setting changes to detergent priming time, current setting will ash on and
off.
2. Press prime button (left rocker to increase and right rocker to decrease). This
changes detergent priming time one second at a time.
3. Once desired time is selected, press and hold cycle button a minimum of three
seconds and no more than ve seconds (after three seconds time will stop
ashing). Release cycle button to accept and move to next setpoint (rinse-aid
priming time).
1. Once setting changes to rinse-aid priming time, current setting will ash on and
off.
2. Press prime button (left rocker to increase and right rocker to decrease). This
changes rinse-aid priming time one second at a time.
3. Once desired time is selected, press and hold cycle button a minimum of three
seconds and no more than ve seconds (after three seconds time will stop
ashing). Release cycle button to accept and move to next setpoint (energy
saver on/off).
TROUBLESHOOTING
HT SETPOINTS
If there is no activity
(button presses) for 30
seconds, display will exit
Setpoints mode without
saving changes.
DETERGENT
PRIMING TIME
RINSE-AID
PRIMING TIME
To exit Setpoints at any
time, hold cycle button a
minimum of six seconds.
Display will stop ashing
and return to wash
temperature. Machine is
ready to operate.
70
77
77
180
177
177