Jacuzzi J-13 - Page 23

23
15. Establish a sanizer reading no less than 1.0 ppm free chlorine or 2.0 ppm bromine, then
allow the swim spa to set undisturbed for 8 hours. Retest water aer 8 hours to
determine if sanizer levels are stable. If sanizer levels are stable, your swim spa is
ready for use. To ensure healthy water condions, always maintain a constant sanizer
reading within the levels recommended on the inside cover of this manual. If sanizer
levels are not stable at this me, it will be necessary to repeat this procedure in its
enrety unl stable sanizer readings are achieved.
IMPORTANT: If the CLEARRAY® ACTIVE OXYGEN water management system is removed from
the swim spa or is not operang effecvely follow the “without CLEARAY® ACTIVE OXYGEN”
chemistry parameters as defined by the Associaon of Pool and Spa Professionals.
16. Aer adequate sanizer levels are achieved, close all swim spa controls to maximize heat
retenon when the swim spa is not in use.